Cutting a Metal Shaft
We began working on a metal shaft at about week 6 of the Introduction to Machining class at George Brown College, after grinding a scriber, toolbits, and cutting angle plates. As a result of the mass...
View ArticleRewards of Showing Up
As a direct result of being the only person to show up for the Circuit Analysis exam review (more because I actually needed it), my professor, who also doubles as the program coordinator, surprisingly...
View ArticleWhat Grade Did You Have?
We started up classes about two weeks ago, and I was highly unmotivated to switch my machining professor (more accurately, my machining master, whom I’m an apprentice under) from an experienced...
View Article
More Pages to Explore .....